💳 Financing Available — Get pre-qualified in minutes with no contractor fees and no stage funding. Apply Now →

Colorado Hot Tub · Evergreen, CO

Hot Tub Pump Repair

Colorado Hot Tub diagnoses and replaces hot tub pumps for foothill homes, from the shop at 26019 CO-74 in Evergreen. A jet pump moves water through the jets. A circulation pump, on tubs that have one, moves a smaller flow across the heater.

What a visit covers

Pump service on this page is for Evergreen, Conifer, Kittredge, Morrison, Bailey, Pine, Idaho Springs, and Georgetown. Call for pricing, and mention the town so we can talk through scheduling and any trip charge.

A loud bearing, a wet-end leak, a hum with no water movement, or jets that died on one pump only are common reasons to call. We do not swap a pump until we check the filter, the valves, an air lock, and whether the control pack is sending power. A clogged filter or a closed slice valve can look like a dead pump.

Pump motors and wet ends are matched to the tub. The label on the pump and the equipment plate tell us the frame, horsepower, and voltage. If the pump can be rebuilt with a wet end or seal instead of a full replacement, we will say so. Call for pricing.

What we check

  • Jet pump versus circulation pump, when the tub has both
  • Filter, slice valves, and air locks before a pump is condemned
  • Seal and wet-end leaks onto the equipment floor
  • Humming, grinding, or a pump that starts and then stops
  • Whether the pack is sending power to that pump

Call for pricing

Colorado Hot Tub

26019 CO-74
Evergreen, CO 80439
Mailing: PO Box 279, Kittredge, CO 80457

Call or text (970) 531-2897 and ask for hot tub pumps. Call for pricing.

Hot Tub Pumps questions

How do I know if my hot tub pump is failing?▾
Common signs are no water movement, a loud grind or squeal, water under the pump, or a hum when you press jets and nothing moves. A dirty filter or a closed valve can mimic a bad pump, so we check those first.
Do you replace both jet pumps and circulation pumps?▾
Yes, when the tub uses them. Some spas have one two-speed jet pump. Others add a small circulation pump for filtration and heat. We identify which pump is at fault before ordering a part.
Will you replace a pump before checking flow?▾
No. We look at the filter, valves, air lock, and whether the control pack is powering the pump. Replacing a pump that was never the problem does not fix the tub.
How much does hot tub pump repair cost?▾
Call for pricing. Cost depends on whether the wet end, the motor, or the whole pump has to be replaced, and on the model. Call (970) 531-2897 with the pump label if you can read it.
Which towns do you cover for pump repair?▾
Evergreen, Conifer, Kittredge, Morrison, Bailey, Pine, Idaho Springs, and Georgetown. Colorado Hot Tub is at 26019 CO-74, Evergreen, CO 80439.